RX7Club.com - Mazda RX7 Forum

3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:
Full Detail Automotive

What goes in threaded hole beside the coolant drain on the engine block?

Thread Tools
 
Search this Thread
 
Old May 7, 2014 | 03:45 PM
Share
  #1  
camajo's Avatar
camajo
Thread Starter
Full Member
Tenured Member: 15 Years
Liked
iTrader: (3)
 
Joined: Oct 2010
Posts: 235
Likes: 2
From: NC
What goes in threaded hole beside the coolant drain on the engine block?
Like the title says, what goes in the threaded hole next to the coolant drain plug on the engine block? I think its obvious what I'm asking, but I'll upload a pic if not.
Reply
0
Old May 7, 2014 | 04:34 PM
Share
  #2  
DaleClark's Avatar
DaleClark
RX-7 Bad Ass
Tenured Member: 20 Years
Liked
Loved
Community Favorite
iTrader: (56)
 
Joined: Jan 2002
Posts: 15,622
Likes: 2,725
From: Pensacola, FL
I don't believe anything does. That may just be left over from the FC, it's motor mount attached to the center iron.

Dale
Reply
0
Old May 7, 2014 | 07:28 PM
Share
  #3  
camajo's Avatar
camajo
Thread Starter
Full Member
Tenured Member: 15 Years
Liked
iTrader: (3)
 
Joined: Oct 2010
Posts: 235
Likes: 2
From: NC
Thanks Dale! I suspected it was not used on the fd, as I could find nothing about i, but in my paranoia, I wanted to be sure.
Reply
0
Old May 7, 2014 | 09:39 PM
Share
  #4  
IRPerformance's Avatar
IRPerformance
Sponsor
iTrader: (41)
 
Joined: Apr 2003
Posts: 11,347
Likes: 321
From: NJ
Its a blind hole. I sometimes mount the big engine ground off the battery harness there.
Reply
0
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
1979 Barn Find - Unable to idle
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM
OMP oil line routing ?
BLK 93
3rd Generation Specific (1993-2002)
4
Aug 19, 2015 03:47 AM
what's our stock oil sensor thread in the 20b rear iron?
stickmantijuana
20B Forum
8
Aug 18, 2015 02:46 PM
Back to Subforum
3rd Generation Specific (1993-2002)
View Next Unread
Anything to do before swapping 929 master to JDM brake booster?




Advanced Search

All times are GMT -5. The time now is 06:30 AM.