Welding the WG for Non-Seq... PICS!!!
#28
Rotary Ninja
Join Date: Oct 2007
Location: Wichita Falls, TX
Posts: 683
Likes: 0
Received 0 Likes
on
0 Posts
#30
Banned. I got OWNED!!!
Join Date: Jul 2004
Location: next to the polishing wheel!!!
Posts: 1,179
Likes: 0
Received 1 Like
on
1 Post
If you weld the prespool doors hole shut and weld up the opening in the hotside port and reshape it the exhast will have a direct flow into the wheel ,not cross flow from two directions .I move the prespool door to the wg position because it is 1 1/10 incher bigger than the wg door .Plus much more in my Rich Mans Non Seq Mod . This mod involves work on all four of the cast iron parts ,Manifold both hot sides and the center dump .The pictures that are the forum that one of my customers took ,do not show the complete job . No way would I trade my BNRs super sized with My Rich Mans set up for a single .
#31
Rotary Freak
IF this goes OK, you might wanna remove the charge control valve, sitting in the alu pipe from rear turbo to Y-pipe and block it of. Once non seq it is n't of any use either.
#32
Rotary Ninja
Join Date: Oct 2007
Location: Wichita Falls, TX
Posts: 683
Likes: 0
Received 0 Likes
on
0 Posts
not totally true you can T the vacuum line from the CRV to the ABV and it will operate like dual BOV's some people do it, as it sounds cool! haha
#35
Rotary Ninja
Join Date: Oct 2007
Location: Wichita Falls, TX
Posts: 683
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM