Weird vibrations
#1
Who say's i need a Van
Thread Starter
iTrader: (18)
Join Date: Feb 2009
Location: Whatsittoya
Posts: 609
Likes: 0
Received 0 Likes
on
0 Posts
Weird vibrations
I started having a rough vibrating when at idle today. The idle itself is stable...not jumpy. With my hands on the wheel its very noticable and strong. I feel like its going to shake apart. engine runs strong and pulls hard. it also boost fine as well.
Changed plugs (9's all around) 6,000miles ago
added twin power less than 1,000miles ago
Has anyone had these symptoms or have any ideas.
Changed plugs (9's all around) 6,000miles ago
added twin power less than 1,000miles ago
Has anyone had these symptoms or have any ideas.
#2
Tucson Rotary
iTrader: (1)
Join Date: Nov 2003
Location: Tucson
Posts: 228
Likes: 0
Received 0 Likes
on
0 Posts
If it is most noticeable ~3K Check water pump, drive belts, pulleys.
General Rule of thumb, If you feel it in the steering wheel, problem is in front of vehicle, If in your butt, flywheel back.
General Rule of thumb, If you feel it in the steering wheel, problem is in front of vehicle, If in your butt, flywheel back.
#4
Tucson Rotary
iTrader: (1)
Join Date: Nov 2003
Location: Tucson
Posts: 228
Likes: 0
Received 0 Likes
on
0 Posts
Still, check the belts and pulleys closely. See if you can feel it whilst putting a hand on the motor. If you have a stethoscope see if you can hear anything. If not use a length of fuel line or vacumn tube.
#5
Who say's i need a Van
Thread Starter
iTrader: (18)
Join Date: Feb 2009
Location: Whatsittoya
Posts: 609
Likes: 0
Received 0 Likes
on
0 Posts
Yes i can feel it while placing my hand on the engine. My belts look worn. The alternator belt has a tare and the rest are cracked. Forgive me, I don't fully understand how belts or pullies could cause vibrations.
#6
Tucson Rotary
iTrader: (1)
Join Date: Nov 2003
Location: Tucson
Posts: 228
Likes: 0
Received 0 Likes
on
0 Posts
Trust me they can, have seen enough to say that could well be your problem especially if you are missing chunks of belt material.
If you are missing a chunk out of one it can cause vibration. They are a rotating mass hitting and running across many pulleys and surfaces.
If they have more than 4 cracks per inch they are suppose to be replaced.
If you are missing a chunk out of one it can cause vibration. They are a rotating mass hitting and running across many pulleys and surfaces.
If they have more than 4 cracks per inch they are suppose to be replaced.
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM