Waste gate
#1
Waste gate
here is the e-mail from cam,
Jason Drove your car and all is well, checking the boost it was going past 10 quick so back at the shop it took 15 psi to start opening, I will check with aspec on the spring, we may need softer. Here are a few more pic.
I bought the 500 R off a-spec. Wouldnt a boost controller fix this. He says i need a softer srping.And that with the min boost its still going over 15psi. He said that when everything is wraped up and cremic coated that its producing so much cold air that it over boots.
Jason Drove your car and all is well, checking the boost it was going past 10 quick so back at the shop it took 15 psi to start opening, I will check with aspec on the spring, we may need softer. Here are a few more pic.
I bought the 500 R off a-spec. Wouldnt a boost controller fix this. He says i need a softer srping.And that with the min boost its still going over 15psi. He said that when everything is wraped up and cremic coated that its producing so much cold air that it over boots.
#2
Double Dose
iTrader: (1)
Boost controller will only add boost above the wastegate spring pressure. If the spring is 15psi then you can't boost less than that. But I don't see why they'd have such a large spring in there. What size wastegate? If it's small it could very well be boost creep. Which a boost controller wouldn't really help eliminate. You'd have to go to a larger wastegate or softer spring so that it would release more exhaust or open sooner. A-Spec's kits are good so I wouldn't imagine the wastegate would be too small
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM