Very bad Idle in gear
#1
Very bad Idle in gear
I dont know wtf happend but I started the car up at the end of the day and it ran fine in neutral
Neutral w/ Clutch Pedal Down = Fine
Soon as U put it in any gear with clutch pedal in it bounces like crazy runs on one rotor as it drops....adding fuel to the idle curve fixes this but requires tons of fuel
Pop it back into neutral...clutch in/out idles perfectly perfect vaccuum
Neutral w/ Clutch Pedal Down = Fine
Soon as U put it in any gear with clutch pedal in it bounces like crazy runs on one rotor as it drops....adding fuel to the idle curve fixes this but requires tons of fuel
Pop it back into neutral...clutch in/out idles perfectly perfect vaccuum
#2
this may be the one thing that pushes me into listing it for sale
please help me guys...i dont know what it is...it has to be some kind of sensor...
local rotary shop over phone says its a vaccuum leak but that doesnt make sense why only in gear does it idle poorly
please help me guys...i dont know what it is...it has to be some kind of sensor...
local rotary shop over phone says its a vaccuum leak but that doesnt make sense why only in gear does it idle poorly
#3
Rotary Enthusiast
iTrader: (1)
Join Date: Feb 2004
Location: UK
Posts: 899
Likes: 0
Received 0 Likes
on
0 Posts
Dont you worry brother,,,easy fix. Same thing happend to me few months back theres a push in switch under the clutch pedal i bet the springs snapped inside and it aint working no more. ill find you a link hang on
#4
Rotary Enthusiast
iTrader: (1)
Join Date: Feb 2004
Location: UK
Posts: 899
Likes: 0
Received 0 Likes
on
0 Posts
here you got mate,,,i followed this wicked repair using a pen spring worked a treat.
https://www.rx7club.com/showthread.p...+switch+repair
thank me later.
https://www.rx7club.com/showthread.p...+switch+repair
thank me later.
#6
well i looked at the switch and the little white pluger comes out almost all the way id say 85%...i can pull it a little bit more out than it does on its own....so my question is it really the switch?
- does the switch have to come ALL the way out in order to work?
- does the switch have to come ALL the way out in order to work?
#7
Racecar - Formula 2000
Dave
Trending Topics
#8
Rotary Enthusiast
iTrader: (1)
Join Date: Feb 2004
Location: UK
Posts: 899
Likes: 0
Received 0 Likes
on
0 Posts
To be honest mine looked fine, and i wasnt gonna remove it but i just thought what the hell and run testing meter over it ,i soon realised that it was not springing back 100% full length.. check it out brother , mine also didnt idle like a pile of crap as soon as i tried to put it in gear.
#9
Rotary Freak
Join Date: May 2001
Location: Peoria, IL
Posts: 1,779
Likes: 0
Received 0 Likes
on
0 Posts
Also, check the first/second gear switch. If it goes bad, it will give you the exact symptoms you are describing. It is up on the side of the tranny. On the tail housing.
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM