vacuum tube 3,5mm--->3mm
#1
Full Member
Thread Starter
Join Date: Sep 2007
Location: Slovenia
Posts: 60
Likes: 0
Received 0 Likes
on
0 Posts
vacuum tube 3,5mm--->3mm
Hello,
I was thinking to do a vacuum job because I found some 3mm silicone tube. Is the size good enough for small vacuum lines or it would cause to much pressure drop? Thanks!
I was thinking to do a vacuum job because I found some 3mm silicone tube. Is the size good enough for small vacuum lines or it would cause to much pressure drop? Thanks!
#2
RX-7 Bad Ass
iTrader: (55)
Read my guide -
https://www.rx7club.com/3rd-generation-specific-1993-2002-16/daleclarks-guide-vacuum-lines-your-fd-904277/
3.5mm fits VERY tight, I think 3mm would be a bit too tight.
I doubt there would be any issue with pressure drop.
Dale
https://www.rx7club.com/3rd-generation-specific-1993-2002-16/daleclarks-guide-vacuum-lines-your-fd-904277/
3.5mm fits VERY tight, I think 3mm would be a bit too tight.
I doubt there would be any issue with pressure drop.
Dale
#5
RX-7 Bad Ass
iTrader: (55)
Probably due to fit, like I said. There's no issues with pressure drop, don't worry about that at all, that's not an issue with the vacuum lines.
Dale
Dale
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
12
10-01-15 07:58 PM