Which vacuum diagram?
#1
Which vacuum diagram?
So I just went in and put in block off plates for everything but the EGR (just for difficulty of reaching it). I can go through and tacke vacuum lines, but should it just follow the simplified sequential at this point? Been trying to double check solenoids before removal and blocking vacuum ports, but if you already know the answer, it will save quite a bit of time for me. Thanks.
#2
RX-7 Bad Ass
iTrader: (55)
Simplified sequential is just sequential without the emissions. If you've removed double throttle, ACV, AWS, etc. you can go that route.
You don't HAVE to remove those solenoids and everything right now. I still have most of my emissions solenoids in place just because I'd rather wait until the engine is out again to mess with it .
Dale
You don't HAVE to remove those solenoids and everything right now. I still have most of my emissions solenoids in place just because I'd rather wait until the engine is out again to mess with it .
Dale
Thread
Thread Starter
Forum
Replies
Last Post
xblazinlv
3rd Generation Specific (1993-2002)
13
03-27-06 10:50 PM