vaccum leak? please help~^^
#1
Full Member
Thread Starter
Join Date: May 2006
Location: Arcadia, CA.
Posts: 234
Likes: 0
Received 0 Likes
on
0 Posts
vaccum leak? please help~^^
Hi everyone~ I'm a newbie that just join the RX7 family. I did search the forum but just can't find the right answer.....the car Runs and drives good, but after warm up the idle surges between (1500~1800), but If electrical devices (fan, lights etc . are in use, idle steady around 2000rpm. please advise~ Thanks in advence
Johnny
Johnny
#3
Full Member
Join Date: Jan 2006
Location: Oslo Norwege
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
i got the same problem, and my car is allmost stock "except catback and openfilter". Ive ordered myself and Pfc to see if its my ecu that is messing around..... I got my rx7 from Japan, dont know if they are flashed my ecu or not
#5
Rotary Enthusiast
iTrader: (1)
Join Date: Feb 2004
Location: UK
Posts: 899
Likes: 0
Received 0 Likes
on
0 Posts
sounds like lack of air past the throttle plates causing the ECU to try and fix the idle,,,,id suggest adjusting the idle speed control up a bit (located in the throttle body,,, some one may need to show u a picture of this,,,,or try do a search),, think this will fix your problem,,,,
#6
Rotary Enthusiast
Join Date: Feb 2005
Location: Charlotte, NC
Posts: 1,336
Likes: 0
Received 0 Likes
on
0 Posts
It could be a problem with the Throttle Body adjustment, or it could be a problem with Idle Speed Control valve itself. It is most likely not a vacuum leak, as the stock ECU will compensate for this and correct the idle.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM
ls1swap
3rd Generation Specific (1993-2002)
12
10-01-15 07:58 PM