vaccum cap size for full non-squential
#3
Lets Go Hokies!
iTrader: (5)
Beware that the vacuum caps sold at most autoparts stores will crack and leak after being in a hot engine bay. I have tried many different caps and all of them eventually crack which forces me to hunt around for the leak... very annoying. I haven't been able to find a good source for quality vacuum caps so what I do is insert a short shouldered bolt into a small piece of vacuum line. While this method looks a bit unprofessional, it works and is very reliable.
#4
Senior Member
iTrader: (3)
i just stuck bolts into vacuum hoses and put zip ties around them. Works for me so far
oh, and you'll need a 20mm plug for one of the hoses on your y-pipe. For that one i used 20mm steel hose (don't know what it was for), cut off a length and hammered/folded one end to seal it
oh, and you'll need a 20mm plug for one of the hoses on your y-pipe. For that one i used 20mm steel hose (don't know what it was for), cut off a length and hammered/folded one end to seal it
#5
VV That's mine VV
Join Date: Jan 2007
Location: Chapel Hill, NC
Posts: 583
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
Frisky Arab
2nd Generation Specific (1986-1992)
13
08-18-15 05:30 PM
rx8volks
Canadian Forum
0
08-11-15 10:30 PM
KAL797
Test Area 51
0
08-11-15 03:47 PM