i kno uhave to upgrade the piping forthe turbos to be able to weld on a bov my question is do i have to go outa nd get a pipe bender and makethem myself or is there a kit i can buy?

 

www.rx7store.net, www.gothamracing.com and several others have the pipes ready for you to buy. I can't recall if any of them have flanges for a BOV valve built in, though. check 'em out.

Jason has it with the BOV flange for $195. Honestly I think building an elbow a one off elbow on your own is not worth the headache, but some people love a challenge. Also this is intended for use with the Greddy BOV.

http://www.rx7store.net/index.asp?Pa...ROD&ProdID=428

 

I think the Greddy Elbow has a flange for a BOV, not sure about any of the other hard pipes.

 

yes thye have. you can get the elbow with the BOV for $380 + the rest of the hard pipes.

You can also use the same location of the stock one.

 

does it comewill all pipes neededto replace all the stock plastic ones? thers a bov stock? does the 350 inclde the bov and all pipes for replacing all the plastic piping

 

it also says its needs an aditional kit for it to fit onto the intercooler, how much is that and where can i get it?

 

This is the pipe set thatyou need to replce the stock ones
http://www.rx7store.net/index.asp?Pa...ROD&ProdID=430 $180

Then you need the elbow with the BOV flange on it
http://www.rx7store.net/index.asp?Pa...ROD&ProdID=428 &380 with BOV

just look at the option and sellect what you need

 

Yes there is a stock one. If you just vent it, it will do the same every other BOV out there do.

 

interesting. theres only 2 pipes u need to replace the oem ones? i thout there were more then that.

 

o and will this affect air fuel ratio at all? j/w im trying to get minor mods out of the way before i get a power fc

 

I don't think it will affect it that much. In fact hard pipes are on my list of things before I get a PFC.

 

To me hard pipes are more like a bling, bling factor for the stock set up.