Update on my FD mods to date
#1
Update on my FD mods to date
Here is a link to pics of my current progress with my FD3S single turbo conversion, mainly brake and clutch and flywheel stuff.
The brakes, AP racing 14 inch front, 13 inch rear will all fit within a 17 inch rim. The comparison pics are with stock front calipers, pads and discs.
The fuel system pics show the Holley low pressure lift pump, the fuel swirl pot, and the big Bosch Motorsport high pressure pump.
The clutch is 5.5 inch, ultra lightweight, titanium cover twin plate. The dual, bias adjustable brake cylinder set up replaces servo and the ABS is removed. Car is RHD Japanese import spec, 1993.
Thumbnails of mods so far, click on them for fullsize images.
The brakes, AP racing 14 inch front, 13 inch rear will all fit within a 17 inch rim. The comparison pics are with stock front calipers, pads and discs.
The fuel system pics show the Holley low pressure lift pump, the fuel swirl pot, and the big Bosch Motorsport high pressure pump.
The clutch is 5.5 inch, ultra lightweight, titanium cover twin plate. The dual, bias adjustable brake cylinder set up replaces servo and the ABS is removed. Car is RHD Japanese import spec, 1993.
Thumbnails of mods so far, click on them for fullsize images.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
10-09-15 10:05 PM