UIM removal
#1
Make an assessment...
Thread Starter
iTrader: (3)
UIM removal
Ok, I'm hoping I won't have to fully remove it. I have to connect a vacuum hose under the UIM and I can't get my hand in there, will I mess up the gasket and need to put a new one on or put some kind of sealant on there when I reconnect it, and how hard is it to remove this? I'm still kinda new to some of the maintenance on this (low funds to this point to do any mods), so any help would be appreciated. Is there a writeup on this somewhere?
#3
Rotary Freak
iTrader: (1)
Join Date: Oct 2003
Location: Hampton, Va
Posts: 2,506
Likes: 0
Received 0 Likes
on
0 Posts
Here's a writup for noobs on removing the UIM:
http://www.clubrx.org/default.asp?id...ntent=63&mnu=5
http://www.clubrx.org/default.asp?id...ntent=63&mnu=5
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
09-11-15 03:29 PM