I have this MBC in my hands...



I searched but can't find info on how to install it. I read Damien's MBC installation but I think he used 2 MBC...anyone has suggestion on how to install this? If you have a pictorial DIY that would be even better =P

Thanks.

 

Install it between the vacuum line that goes to the wastegate actuator. I believe the side port comes from the vacuum source and the bottom line goes to the wastegate. You may want to double check that though.

Kevin

 

can someone confirm this?

 

bump for some advice

 

here ya go. This will work fine. Just replace the EBC with a MBC. I am running the third option (version 2).

 

^^^
Thanks for your help but the image is not showing up!

 

yeah can someone plz place a picture diagram plz...i would also like to know.

 

hmmmm lets see if this works....






Is that any better?

thanks,
-josh

 

hmmmm...is this the correct way of setting MBC?

 

I use version 1 with an MBC. This setup relies on the factory pre-control solenoid, and the MBC controls boost via the wastegate only. This works well for me - I can still control primary boost (and secondary pre-spool) via the PFC duty setting, up to the limit set by the MBC.

If you need to know which port is the inlet/outlet, check their website for instructions.

 

Well I have been running version 2 for about 2 years now with no issues. Works great IMO. I get a very predictable and fast spool of the turbos, yet transition is not violent at all. I would recommend it to anyone, but then again.....just my .02


goodluck and hope this helped,
-josh