Turbo Problem Please Help
#1
Full Member
Thread Starter
Join Date: Jul 2004
Location: CT
Posts: 236
Likes: 0
Received 0 Likes
on
0 Posts
Turbo Problem Please Help
So I decided to install my new efini Y pipe today, and just as I am bolting it in, on the last turn of the bolt, it snaps and is now flush with the turbo. I tried using an easy out but that broke in it also. My last option now seems to be to take out the turbos and get it to a machine shop to drill out the hole (my drill bits slide around the easy out). Any reccomendations/suggestions? Any help would be GREATLY appreciated! Thank you.
#2
il Cosa Nostra e vivo!!
iTrader: (1)
Join Date: May 2003
Location: Dove le cose sono fatte il vecchio moda il senso
Posts: 2,097
Likes: 0
Received 0 Likes
on
0 Posts
No need to take the twins off. If you can't take the broken stud out, just drill through the entire stud and use a bolt/washer--- lock washer/nut combo with OEM metal gasket to tighten the flange. It should work fine.
AMENDMENT:
My method only applies to the Secondary Turbo "inside" (top) stud.
AMENDMENT:
My method only applies to the Secondary Turbo "inside" (top) stud.
Last edited by areXseven; 08-15-04 at 05:40 PM.
#3
Full Member
Thread Starter
Join Date: Jul 2004
Location: CT
Posts: 236
Likes: 0
Received 0 Likes
on
0 Posts
I already took the stud out, and used a bolt and washer, which I am guessing bottomed out and then broke and is now flush with the top of the hole, and then I used an easy out to try and free that but it broke, which means I can no longer drill through it (too hard of a metal). So I am left with taking the entire turbo assembly out and then bringing it to a machine shop to have them put it in a drill press to get it out.
Thread
Thread Starter
Forum
Replies
Last Post
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM
Frisky Arab
2nd Generation Specific (1986-1992)
13
08-18-15 05:30 PM