3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

tripoint did my compression test

Thread Tools
 
Search this Thread
 
Old Jun 3, 2002 | 04:32 AM
  #1  
trunks's Avatar
Thread Starter
Full Member
Tenured Member 10 Years
 
Joined: Mar 2002
Posts: 192
Likes: 0
From: earth
tripoint did my compression test

i had a compression test at tri point a while back.
mark said that i had 90 on the first rotor and
80 on the second one. are those good numbers?
that was my first time at tri point so i didnt really
take tri points advice seriously. mark said the second rotor is running slower. i was a newbie then and still am.
help.
Reply
Old Jun 3, 2002 | 08:36 AM
  #2  
jdhuegel1's Avatar
Glug Glug Glug Burp
Tenured Member 05 Years
 
Joined: Jan 2002
Posts: 3,819
Likes: 0
From: Scott AFB, IL
Numbers closer to 110 120 are close to perfect I think... I'm not sure if 80 and 90 are that low or not...anyone?
Reply
Old Jun 3, 2002 | 08:44 AM
  #3  
jdhuegel1's Avatar
Glug Glug Glug Burp
Tenured Member 05 Years
 
Joined: Jan 2002
Posts: 3,819
Likes: 0
From: Scott AFB, IL
https://www.rx7club.com/forum/showth...mpression+test

Sorry, here it is!
Reply
Old Jun 3, 2002 | 08:49 AM
  #4  
airborne's Avatar
King of the Duct Tape
Tenured Member 15 Years
 
Joined: Feb 2001
Posts: 1,177
Likes: 0
From: PA
the numbers are a bit low but the differential isn't terrible. manual says the differential limit is 21psi.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
ZacMan
Build Threads
4
Sep 19, 2015 09:20 PM
BLK 93
3rd Generation Specific (1993-2002)
11
Sep 9, 2015 10:56 AM
SCinfidel
3rd Generation Specific (1993-2002)
4
Sep 8, 2015 05:36 PM
ZaqAtaq
New Member RX-7 Technical
2
Sep 5, 2015 08:57 PM




All times are GMT -5. The time now is 03:24 PM.