I'm replaceing all the banjo washers on my turbos and the manual doesn't seem to have the specs. I've got the oil feed and return fiting specs, just not the banjo ones. thanks.

 

You want just enough torque to crush the crush washers - I can typically feel it by hand.

The torque for the oil drain plug is most likely about the same, as it's a similar sized fastener. Or, the banjo bolt for the oil feed line that bolts to the top of the front iron of the block. Those would be good similar reference points for torque value.

Dale

 

I have been using 20ftlbs on the water and 15ftlbs on the oil crush washers when using new ones.

 

The manual says 65 - 91 inch pounds. Page F-91.