I am driving on stock wheels, stock size tires, and stock suspension. When I turn hard left or right, my tires are rubbing on the fender liners on the very bottom inner edge of the fender liner. Has anyone else experienced this issue?

I did just re-install them, but it's not like you can install them incorrectly (or so I thought), so I'm just curious why this is happening and what I need to do differently..

 

What did you recently install? If you just did the suspension it might just need an alignment. That would be my first guess.

 

Is this occurring on both sides?

Have you tried to wiggle the fender liner to see if its loose in those areas?
Perhaps you forgot a clip, or it didn't seat correctly.

 

Most likely the front spring perches are worn out and sagging. Very common problem. Typically the driver's side is a good 1/2" to 3/4" lower than it should be.

Parts are about $60 each or so from Ray and it's not too bad of an install.

I would also double check that the fender liners aren't torn, sagging, etc. as well.

Dale

 

I installed new oil coolers. I had to remove the fender liners to route the lines. I did not touch any of the suspension components.
Yes, both sides. Nothing feels or looks loose.

Other than looking like they are 20+ years old they appear to be functionally sound.

Would pictures help?

 

Never had any issue rubbing with OEM wheels, and I ran 245/45's and was lowered a little.
If they didn't rub before you removed and replaced them and you didn't change anything, then just double check your work. Maybe those lines are pushing them out or deforming them in some way....something.