throttle position sensor
#1
935 Wicked Dragger East
Thread Starter
Join Date: Dec 2006
Location: atlanta
Posts: 378
Likes: 0
Received 0 Likes
on
0 Posts
throttle position sensor
my ck engine light is on and the codes say its the TPS. how much would it cost for another TPS, whats the labor time on replacing one and more importantly what does it even look like . any help would be appreciated. thanks
#2
Mr. Links
iTrader: (1)
I don't know how much they are new, but you could probably find a used one for a decent price (ask Fritz Flynn).
As far as installing, its only two bolts/screws. However, after installation it needs to be calibrated:
https://www.rx7club.com/3rd-generation-specific-1993-2002-16/fixed-my-idle-problems-backfiring-bucking-more-170731/
I would verify the actual TPS is bad rather than a connector or wiring problem. That connector seems to get broken quite a bit because it can be a pain to get off at time (so people use some tools to help out which they probably shouldn't ).
As far as installing, its only two bolts/screws. However, after installation it needs to be calibrated:
https://www.rx7club.com/3rd-generation-specific-1993-2002-16/fixed-my-idle-problems-backfiring-bucking-more-170731/
I would verify the actual TPS is bad rather than a connector or wiring problem. That connector seems to get broken quite a bit because it can be a pain to get off at time (so people use some tools to help out which they probably shouldn't ).
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM