Throttle Position Sensor
03-31-03, 12:56 AM
#1
Senior Member
Thread Starter
Join Date: Apr 2002
Location: Greensboro, NC
Posts: 402
Likes: 0
Received 0 Likes
on
0 Posts
Throttle Position Sensor
I broke the connection to my TPS during the Vacuum Hose job and am going to order a new one.
How do you set it in the Throttle body? I've talked with someone already and he said the two prongs that stick out on the TB itself have to be pushed into the plastic connector. Then the sensor has to be adjusted after you have it on by keeping the screws loose. Is there a procedure in the factory manual that I am missing? How do you get it on without messing anything up?
How do you set it in the Throttle body? I've talked with someone already and he said the two prongs that stick out on the TB itself have to be pushed into the plastic connector. Then the sensor has to be adjusted after you have it on by keeping the screws loose. Is there a procedure in the factory manual that I am missing? How do you get it on without messing anything up?
03-31-03, 11:39 AM
#3
Rotary Freak
BS --You do not press it in to the anything.. Easy it just sets beside the two flats that rotate it . It returns on its own spring, just look for your self . If you press it to the metal you will break a $150 part. This is not hard to look at and reason out.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM