Think my coils are bad, what are some common symptoms?
#1
Lawn Ornament
Thread Starter
Think my coils are bad, what are some common symptoms?
I checked the resistance on them and it is 1.0, 1.2, and 1.3 respectively form front to back. Manual says <1.0 is good, before i started my 5 spd conversion it took it for a drive and it was real sluggish, RPM's raised and fell very slowly....
#2
How did you check the reistance? With the computer from Mazda? Or just sitting?
Anyway, soooooo many syptoms its hard to tell you. I have ***** one set, I think Im working on my second set hehe Bad driving hehe..
NO POWER is a good start, butt loads of boost, but the engine just doesnt work, so you go nowhere in a long time. Mis-fire at high rpms 6,7, or around those, but it will always happen if its the coils.. Weither your driving or sitting, it will always run like POOP!
Jason
www.jt-imports.com
Anyway, soooooo many syptoms its hard to tell you. I have ***** one set, I think Im working on my second set hehe Bad driving hehe..
NO POWER is a good start, butt loads of boost, but the engine just doesnt work, so you go nowhere in a long time. Mis-fire at high rpms 6,7, or around those, but it will always happen if its the coils.. Weither your driving or sitting, it will always run like POOP!
Jason
www.jt-imports.com
#4
Lawn Ornament
Thread Starter
I checked it with a regular digital ohm meter, not sure, those numbers are from front of the car to the back, I dont have a manual handy so i couldn't tell ya off hand!
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
SakeBomb Garage
SakeBomb Garage
0
09-04-15 05:20 PM
SakeBomb Garage
Vendor Classifieds
0
09-04-15 05:19 PM