I just got in a shippment of block off plates but i didn't relize how much of a PIA getting all the little studs was going to be. Has anyone done this and found and easier way. I'm maily talking about the ones on the LIM.

Thanks
~Luke

 

put two nuts on the stud and tighten them together very tight then put your tool on the bottom nut and turn . The stud should back out . If you hit the end of the stud sharply with a hammer it will help ,this hit is referred to as setting the threads.

 

If you are willing to replace the stud, attach a single nut with red locktite.