is there anybody who makes a new manifold and ext. waste gate
09-09-04, 02:20 AM
#3
Senior Member
Join Date: Jun 2003
Location: Minden, NV
Posts: 494
Likes: 0
Received 0 Likes
on
0 Posts
I just got this model done and I am going to start making this. My hope is to be able to a) use better turbos, because the stockers suck! and b) Still run sequential using a wastegate for pre-spool and 2 butterfly valves, one in the exhaust (as shown) and one in the IC piping, both will be on the same RPM control.
09-09-04, 02:21 AM
#4
Senior Member
Join Date: Jun 2003
Location: Minden, NV
Posts: 494
Likes: 0
Received 0 Likes
on
0 Posts
couple more. You also have to imagine how it would look if it were actually bent steel tubing, or if I knew how to actually use a 3d program.
Last edited by EpitrochoidMan; 09-09-04 at 02:28 AM.
09-09-04, 02:42 AM
#5
The Spirit of FLUFF!
iTrader: (1)
Join Date: Oct 2002
Location: East Highland, CA
Posts: 1,350
Likes: 0
Received 0 Likes
on
0 Posts
I talked with someone about making a SS exhaust manifold for the stock twins and he is looking into it right now. I'll let you know what they say and how much we are looking at.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
rx8volks
Canadian Forum
0
08-11-15 10:30 PM
