Will do once I get home thank you sir

 

Ill be posting a picture later, I did find out it’s ID 1000 primary and 1700 secondary, does that help or not enough info?

 

If you know what they are, then what is the question? In case "ID" is the confusing part, ID stands for Injector Dynamics which is one of the best manufacturers/brands.

 

On the Rywire website for the harness there’s different options there’s: Bosch EV6 or Bosch EV1, Bosch EV14, and some other brands but I think Bosch makes ID so there’s 3 options and I’m not sure which one I need

 

I see. Based on the ID website, they are based on EV14. Although I think the electrical connector is typically the same for EV6.

From ID website.

 

Thank you, yeah I think it is the EV14, here’s a picture

 

That's an EV6 (aka USCAR) connector. I just installed a set of new ID-1050XDS & ID-1700XDS injectors in my FD, and it's the same connector.

 

even the ID website states it’s EV14. Is the XDS model different?

regardless. Connectors should be the same:

 

I don't think the connectors are any different between the older ID injectors and the current ID XDS series injectors. I've got the older ID's on my FC, will need to take a look. But yeah, the pictured connectors are the same. I've seen the terms EV14 and EV6 thrown around interchangeably when referring to that pictured connector.

 

Yeah so the rywire website says that, that connector is the EV14, the EV6 looks different on there so I'll be going with the EV14 since thats what it looks like, thank you!

 

Well. Let's hope for the best. Can always repin it if needed.

 

Yes sir hopefully, will find out soon. Anything I should know when replacing the harness?

 

Nothing special. Make sure there is no risk of rubbing against sharp things. If in doubt, throw some Tessa tape on it. And Don't mix up the connectors.

 

Gotcha, will come back to this once I get the harness and install it, thank you all!

 

Have a question about the engine harness, my car has the adaptronic ecu and was wondering if I would need to take that into account when buying the harness, I was thinking of buying it from rywire but not sure if it would compatible

 

You will need to speak with whoever you plan to buy it from. If it’s a custom harness, then they would likely build it specifically for the ECU. Would recommend contacting C. Ludwig on here. He makes the best.

if your ecu is a plug and play, then I would just get an OEM harness.

 

Will do thank you!