Stock single oil cooler line routing
03-03-17, 04:58 AM
#1
Full Member
Thread Starter
Join Date: Oct 2011
Location: Wilmington, NC
Posts: 220
Likes: 0
Received 0 Likes
on
0 Posts
Stock single oil cooler line routing
I need a pic of how the stock single oil cooler lines are supposed to be run.
As long as we have had the car the line is routed in a manner that causes it to kink.
Thanks
As long as we have had the car the line is routed in a manner that causes it to kink.
Thanks
03-03-17, 01:42 PM
#3
Full Member
Thread Starter
Join Date: Oct 2011
Location: Wilmington, NC
Posts: 220
Likes: 0
Received 0 Likes
on
0 Posts
Thanks!
But the problem is the exact route the line follows causes the rubber line to kink badly enough that it failed once already.
I think that the oil cooler might not be in the exact spot that it should be. Possibly too close too the passenger side of the car.
A picture showing the oil cooler mounted correctly would help a lot.
But the problem is the exact route the line follows causes the rubber line to kink badly enough that it failed once already.
I think that the oil cooler might not be in the exact spot that it should be. Possibly too close too the passenger side of the car.
A picture showing the oil cooler mounted correctly would help a lot.
03-04-17, 04:08 PM
#4
Full Member
Thread Starter
Join Date: Oct 2011
Location: Wilmington, NC
Posts: 220
Likes: 0
Received 0 Likes
on
0 Posts
It is hard to get a good picture but this is the line that is kinked. ( upper line where it turns 90 degrees)
Last edited by High_Carb_Diet; 03-04-17 at 04:10 PM. Reason: add text
03-05-17, 08:09 AM
#6
Full Member
Thread Starter
Join Date: Oct 2011
Location: Wilmington, NC
Posts: 220
Likes: 0
Received 0 Likes
on
0 Posts
Is this the correct part?
https://www.atkinsrotary.com/store/9...2-14-710D.html