I bought a Stack ST8130 from SARD (model ST868), and had some questions to make sure i can install it in a short time...

1. There are 3 sensors that need to be placed:
- oil pressure
- oil temp
- water temp

all 3 Sensors are 1/8 NPTF (also called BSP in europe), can anyone tell me if theres any chance for a direct placement in a 13B-REW engine?

Or there are M10 holes (plugged) that can be used, as i can get some 1/8 NPTF to M10/1 adapters?

2. There is a female "ES" (engine speed) connector, but i'm not sure if it needs to be connected (because theres no male conector, and i got everything out of a running car, and it might have been plugged away)

3. the wheel speed sensor (perhaps the dash gets the engine speed from there) has a red and black connector plus a pink cable - i guess red/black is for battery/ground and the pink cable is the sensor cable from the ECU?

4. like the ES female connector, there are connector for "A" - fuel pressure and "AL" - alarm warning light. I didn't know if its enough to get sensors or needs the dash to be reprogrammed?