3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

Squealing Noise w/video HELP!!!

Old Mar 3, 2011 | 04:20 PM
  #1  
korea_senpai's Avatar
Thread Starter
Touge Specialist (Maybe)
Tenured Member 05 Years
iTrader: (25)
 
Joined: May 2009
Posts: 573
Likes: 0
From: Pittsburgh, PA
Squealing Noise w/video HELP!!!

http://www.youtube.com/watch?v=oayq9Rjus2M

I can't figure it out, I thought it might be the ACV but I removed it, I've check all my hoses and found none disconnected..... help please. Thanks.

Bin

Last edited by korea_senpai; Mar 3, 2011 at 04:28 PM.
Reply
Old Mar 3, 2011 | 04:21 PM
  #2  
korea_senpai's Avatar
Thread Starter
Touge Specialist (Maybe)
Tenured Member 05 Years
iTrader: (25)
 
Joined: May 2009
Posts: 573
Likes: 0
From: Pittsburgh, PA
And yes Toto-Africa is playing in the background, I've been on an 80's kick lately.
Reply
Old Mar 3, 2011 | 05:43 PM
  #3  
korea_senpai's Avatar
Thread Starter
Touge Specialist (Maybe)
Tenured Member 05 Years
iTrader: (25)
 
Joined: May 2009
Posts: 573
Likes: 0
From: Pittsburgh, PA
And the idle is around 1500 I've adjusted the dash pot and tps and its still a bit high.
Reply
Old Mar 3, 2011 | 05:52 PM
  #4  
rx7rcer09's Avatar
Sir Braps A lot
Tenured Member 10 Years
 
Joined: Jul 2006
Posts: 2,001
Likes: 1
From: Hilliard, OHIO
ive never heard that before, possible vac line leak? do you have a boost gauge? if so what is the vac reading at idle. as for high idle a line that is off could cause that but there is the AAS screw if you take the intake elbow off, its center on the bottom of the upper intake manifold but i would look first for a vac leak.
Reply
Old Mar 3, 2011 | 05:53 PM
  #5  
MR_Rick's Avatar
Planning my come back
Tenured Member 20 Years
iTrader: (7)
 
Joined: Feb 2003
Posts: 3,393
Likes: 0
From: Austin, Tx
Do you get full boost and does it do the noise when you are boosting?

Also check your block off plates.
Reply
Old Mar 3, 2011 | 05:56 PM
  #6  
rx7rcer09's Avatar
Sir Braps A lot
Tenured Member 10 Years
 
Joined: Jul 2006
Posts: 2,001
Likes: 1
From: Hilliard, OHIO
Originally Posted by hondasr4kids
Do you get full boost and does it do the noise when you are boosting?

Also check your block off plates.
agreed but after listening to the video again well about 3 times the noise seems to sound louder and at a different rate when the throttle cable is pulled. its having me lean more towards a vac leak.
Reply
Old Mar 3, 2011 | 06:07 PM
  #7  
korea_senpai's Avatar
Thread Starter
Touge Specialist (Maybe)
Tenured Member 05 Years
iTrader: (25)
 
Joined: May 2009
Posts: 573
Likes: 0
From: Pittsburgh, PA
I've got about 6-7 of vacuum at idle, I haven't driven it yet. I've got a Vacuum hose diagram and I can't seem to find the culprit. But it keeps idling high.
Reply
Old Mar 3, 2011 | 06:12 PM
  #8  
rx7rcer09's Avatar
Sir Braps A lot
Tenured Member 10 Years
 
Joined: Jul 2006
Posts: 2,001
Likes: 1
From: Hilliard, OHIO
Originally Posted by korea_senpai
I've got about 6-7 of vacuum at idle, I haven't driven it yet. I've got a Vacuum hose diagram and I can't seem to find the culprit. But it keeps idling high.
6-7 PSI? if so you have a major leak.
Reply
Old Mar 3, 2011 | 06:22 PM
  #9  
korea_senpai's Avatar
Thread Starter
Touge Specialist (Maybe)
Tenured Member 05 Years
iTrader: (25)
 
Joined: May 2009
Posts: 573
Likes: 0
From: Pittsburgh, PA
Will a vacuum leak cause rough idle, though?
Reply
Old Mar 3, 2011 | 06:26 PM
  #10  
rx7rcer09's Avatar
Sir Braps A lot
Tenured Member 10 Years
 
Joined: Jul 2006
Posts: 2,001
Likes: 1
From: Hilliard, OHIO
Originally Posted by korea_senpai
Will a vacuum leak cause rough idle, though?
yes its possible depending on where the leak is and how bad it is.


also is the car drivable, i just thought of something. what is the max PSI you hit while in boost after playing the video again it could be but i highly doubt what sounds like metal metal maybe your turbos are bad?
Reply
Old Mar 3, 2011 | 06:28 PM
  #11  
korea_senpai's Avatar
Thread Starter
Touge Specialist (Maybe)
Tenured Member 05 Years
iTrader: (25)
 
Joined: May 2009
Posts: 573
Likes: 0
From: Pittsburgh, PA
Hmmmmmm, maybe I should take out the rats nest and see if I can find it.
Reply
Old Mar 3, 2011 | 06:34 PM
  #12  
rx7rcer09's Avatar
Sir Braps A lot
Tenured Member 10 Years
 
Joined: Jul 2006
Posts: 2,001
Likes: 1
From: Hilliard, OHIO
Originally Posted by korea_senpai
Hmmmmmm, maybe I should take out the rats nest and see if I can find it.
you can always take that approach, but why not try the basics first spray some soapy water on the rats nest and look for bubbles. if that does not work get to pulling also for idle check the Map sensor hose sometime that comes unplugged and caused idle issues.
Reply
Old Mar 3, 2011 | 06:45 PM
  #13  
MR_Rick's Avatar
Planning my come back
Tenured Member 20 Years
iTrader: (7)
 
Joined: Feb 2003
Posts: 3,393
Likes: 0
From: Austin, Tx
Originally Posted by rx7rcer09
yes its possible depending on where the leak is and how bad it is.


also is the car drivable, i just thought of something. what is the max PSI you hit while in boost after playing the video again it could be but i highly doubt what sounds like metal metal maybe your turbos are bad?
That was the direction I was going. It sounds like a compressor wheel hitting the housing, but the weird part is that it doesn't do it all the time, apparently only during vacuum.


Long shot but check your BOV, CRV by unplugging them.
Reply
Old Mar 3, 2011 | 06:52 PM
  #14  
rx7rcer09's Avatar
Sir Braps A lot
Tenured Member 10 Years
 
Joined: Jul 2006
Posts: 2,001
Likes: 1
From: Hilliard, OHIO
Originally Posted by hondasr4kids
That was the direction I was going. It sounds like a compressor wheel hitting the housing, but the weird part is that it doesn't do it all the time, apparently only during vacuum.


Long shot but check your BOV, CRV by unplugging them.
this is a possibility but would a stock Blow off valve make that noise if stuck?

on another note to the OP if its the turbos are you noticing blueish smoke at start up or a clucking noise from the exhaust side of the motor? and if discovered your turbos are blow DO NOT START THE CAR AGAIN pull the oil pan asap and remove all shavings from the oil pan and the pick up screen.
Reply
Old Mar 3, 2011 | 07:00 PM
  #15  
MR_Rick's Avatar
Planning my come back
Tenured Member 20 Years
iTrader: (7)
 
Joined: Feb 2003
Posts: 3,393
Likes: 0
From: Austin, Tx
Originally Posted by rx7rcer09
this is a possibility but would a stock Blow off valve make that noise if stuck?
Well the it also sounds like when you blow the air out of a balloon when squeezing the fill tube, like the video below. So I was thinking that the BOV or CRV is partially open.

http://www.youtube.com/watch?v=8CJph5erLf0
Reply
Old Mar 3, 2011 | 07:00 PM
  #16  
korea_senpai's Avatar
Thread Starter
Touge Specialist (Maybe)
Tenured Member 05 Years
iTrader: (25)
 
Joined: May 2009
Posts: 573
Likes: 0
From: Pittsburgh, PA
CRV sorry terminology is lost on me.
Reply
Old Mar 3, 2011 | 07:03 PM
  #17  
MR_Rick's Avatar
Planning my come back
Tenured Member 20 Years
iTrader: (7)
 
Joined: Feb 2003
Posts: 3,393
Likes: 0
From: Austin, Tx
CRV= Charge Relief Valve. The other BOV looking thing that is behind the BOV
Reply
Old Mar 3, 2011 | 07:08 PM
  #18  
rx7rcer09's Avatar
Sir Braps A lot
Tenured Member 10 Years
 
Joined: Jul 2006
Posts: 2,001
Likes: 1
From: Hilliard, OHIO
love the quick science lesson i hope for the OP that its a simple hose rather than turbos. set up looks pretty nice.
Reply
Old Mar 3, 2011 | 07:15 PM
  #19  
korea_senpai's Avatar
Thread Starter
Touge Specialist (Maybe)
Tenured Member 05 Years
iTrader: (25)
 
Joined: May 2009
Posts: 573
Likes: 0
From: Pittsburgh, PA
Well I just swapped out my stockers for BNR stage 3s and when I put everything back together problems started up.
Reply
Old Mar 3, 2011 | 07:21 PM
  #20  
rx7rcer09's Avatar
Sir Braps A lot
Tenured Member 10 Years
 
Joined: Jul 2006
Posts: 2,001
Likes: 1
From: Hilliard, OHIO
Originally Posted by korea_senpai
Well I just swapped out my stockers for BNR stage 3s and when I put everything back together problems started up.
Brian's turbos are a very high quality unit, i would send him the video and see if he notices anything weird about them. how long have you had the turbos for? was install done by you or a shop?
Reply
Old Mar 3, 2011 | 07:25 PM
  #21  
korea_senpai's Avatar
Thread Starter
Touge Specialist (Maybe)
Tenured Member 05 Years
iTrader: (25)
 
Joined: May 2009
Posts: 573
Likes: 0
From: Pittsburgh, PA
By myself, but I labeled everything so I knew where everything went.
Reply
Old Mar 3, 2011 | 07:29 PM
  #22  
rx7rcer09's Avatar
Sir Braps A lot
Tenured Member 10 Years
 
Joined: Jul 2006
Posts: 2,001
Likes: 1
From: Hilliard, OHIO
Originally Posted by korea_senpai
By myself, but I labeled everything so I knew where everything went.
okay, a quick check i would perform on the turbos is pull the downpipe off and inspect the exhaust side turbine on the rear turbo check for damage and shaft play. without physically being able to check things on the car ill try to keep helping you. but as i said start with the little things and work to the bigger harder jobs.

also i forgot to ask when did the issue occur? was it after a drive, while getting into the boost?
Reply
Old Mar 3, 2011 | 07:37 PM
  #23  
korea_senpai's Avatar
Thread Starter
Touge Specialist (Maybe)
Tenured Member 05 Years
iTrader: (25)
 
Joined: May 2009
Posts: 573
Likes: 0
From: Pittsburgh, PA
I haven't even driven it since I put the turbos on.
Reply
Old Mar 3, 2011 | 07:49 PM
  #24  
MR_Rick's Avatar
Planning my come back
Tenured Member 20 Years
iTrader: (7)
 
Joined: Feb 2003
Posts: 3,393
Likes: 0
From: Austin, Tx
I was doing some reading on your issue. Do this before you take the downpipe off. Remove the crossover pipe on the y-pipe. and start the car and see if the noise still there. If it is gone then you ave a leak some where.

This guy seems to had the same problem

https://www.rx7club.com/showthread.p...ight=squealing
Reply
Old Mar 3, 2011 | 07:51 PM
  #25  
korea_senpai's Avatar
Thread Starter
Touge Specialist (Maybe)
Tenured Member 05 Years
iTrader: (25)
 
Joined: May 2009
Posts: 573
Likes: 0
From: Pittsburgh, PA
The noise is coming from under the UIM, its not really from the turbo downpipe area. I really don't what to take the turbos off again, my car is RHD and the steering column is annoying and in the way

Last edited by korea_senpai; Mar 3, 2011 at 07:54 PM.
Reply

Thread Tools
Search this Thread

All times are GMT -5. The time now is 11:07 AM.