Some ?'s on E6K
#1
Senior Member
Thread Starter
Join Date: Aug 2001
Location: Tampa, Florida
Posts: 576
Likes: 0
Received 0 Likes
on
0 Posts
Some ?'s on E6K
Ok, How do you hook up the igniter/coils to the Haltech? (3rd gen w/ factory ignition)Do you need the igniter/resistor? I posted here cause the Haltech room is like a ghost town. Please help.
#2
Lives on the Forum
LOL!!
picture the igniter on its side with the wires facing to the right. the one unused wire spot at the bottom. top wire being pin A
A= dig out 2 (blue)
B= neg side of trailing 1 (will be your front rotor)
C= dig out 1 (white and black)
D= connect this to a switched 12v source.
E= neg on trailing 2 (rear rotor)
F= haltech's ign out (its the lt green wire)
G= to the negative of the leading pack
H= gets no connection
in the setup page set it like this.
output type: constant charge
output edge: falling
time: 3ms
type: rotary
spark mode: direct fire
i had a problem with this when i first hooked it up but this is seems to work fine. PM me if you have a question. hopefully i can help.
picture the igniter on its side with the wires facing to the right. the one unused wire spot at the bottom. top wire being pin A
A= dig out 2 (blue)
B= neg side of trailing 1 (will be your front rotor)
C= dig out 1 (white and black)
D= connect this to a switched 12v source.
E= neg on trailing 2 (rear rotor)
F= haltech's ign out (its the lt green wire)
G= to the negative of the leading pack
H= gets no connection
in the setup page set it like this.
output type: constant charge
output edge: falling
time: 3ms
type: rotary
spark mode: direct fire
i had a problem with this when i first hooked it up but this is seems to work fine. PM me if you have a question. hopefully i can help.
Thread
Thread Starter
Forum
Replies
Last Post
kamikazeRyan
Haltech Forum
6
12-23-01 11:42 AM