Some pics of my RX-7 slightly moded
Trending Topics
#14
Rotary Enthusiast
Thread Starter
Join Date: Oct 2001
Location: Canada
Posts: 1,020
Likes: 0
Received 0 Likes
on
0 Posts
Yes, if I keep the car a 3 rotor is going in this Winter and I will be selling this engine with the PFC and every thing on it including the turbo kit .
GT 67/63 wheel with a .96 hotside is the turbo. If someone can host a vid I just did a quick one of it idleling and reving Her a bit.
I might put it for sale but am having a very hard time doing so because I have put many hours,scraped knuckles and money into it.
GT 67/63 wheel with a .96 hotside is the turbo. If someone can host a vid I just did a quick one of it idleling and reving Her a bit.
I might put it for sale but am having a very hard time doing so because I have put many hours,scraped knuckles and money into it.
#16
Rotary Enthusiast
Thread Starter
Join Date: Oct 2001
Location: Canada
Posts: 1,020
Likes: 0
Received 0 Likes
on
0 Posts
I had it on the dyno 2 years ago with an Apexi RX-6 and was putting out 380 RWHP at fairly low boost. I changed to a T-72 then to this GT wheel and run a bit higher boost. When I actually get to drive it I run around 20-22 psi on the street so it pulls much harder then the Apexi turbo and I have only but dyno tuned with the datalogit.
#24
Rotary Enthusiast
Thread Starter
Join Date: Oct 2001
Location: Canada
Posts: 1,020
Likes: 0
Received 0 Likes
on
0 Posts
The wing is a JSP blade with 3" brackets and only 56" wide I think?
The Corbeau seats fit perfect and they are mounted on the cobeau brackets made for the FD.
Thanks again.
The Corbeau seats fit perfect and they are mounted on the cobeau brackets made for the FD.
Thanks again.