Routing of overflow return line
#1
Rotary Enthusiast
Thread Starter
iTrader: (1)
Join Date: Dec 2007
Location: University Place, WA
Posts: 1,151
Likes: 0
Received 0 Likes
on
0 Posts
Routing of overflow return line
I was installing an intake heat shield and found that the coolant line that runs from the AST to the overflow tank is in the they way. I'm guessing that a PO at some point shortened up the line. I've checked the FSM to see if I can find out where that line would normally be routed stock but couldn't find it. Can anyone tell me where that coolant return line should run?
My FD currently has it running down from the AST, along the brace right behind the rad, then angles up towards the overflow tank. The problem is that is where the heat shield would go.
My FD currently has it running down from the AST, along the brace right behind the rad, then angles up towards the overflow tank. The problem is that is where the heat shield would go.
Thread
Thread Starter
Forum
Replies
Last Post
[For Sale] Scratch & Dent, Used, and Open-Box Sale!
SakeBomb Garage
Vendor Classifieds
5
08-09-18 05:54 PM
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
10-09-15 10:05 PM
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM