Reverse Light Question
10-08-07, 08:21 PM
#1
Senior Member
Thread Starter
Join Date: Aug 2006
Location: next door
Posts: 340
Likes: 0
Received 0 Likes
on
0 Posts
Reverse Light Question
im missing the block connector. so just wondering if, the red wire is +, black is -, whats the red/yellow for?iv got a fue blub holders luyin round and cut one up to make it fit ,so just trying to wire it up.tryed to find wiring diagram but my computers havin problems downloading it.and im not great with electrics ,thanks for any help
10-08-07, 08:53 PM
#2
94 Single Turbo FD
Join Date: May 2006
Location: Calgary, Alberta, Canada
Posts: 1,418
Likes: 0
Received 0 Likes
on
0 Posts
haha....
first off....dont post after u come home for the local tavern.
i have no idea what u are tying 2 ask bro.
your spelling and sentence structure is horrible.
dont take offence ... i am irish 2
first off....dont post after u come home for the local tavern.
i have no idea what u are tying 2 ask bro.
your spelling and sentence structure is horrible.
dont take offence ... i am irish 2
10-09-07, 09:43 AM
#4
Senior Member
Thread Starter
Join Date: Aug 2006
Location: next door
Posts: 340
Likes: 0
Received 0 Likes
on
0 Posts
the reverse lights ,when i took of the caseing at the bumper, theres no blub,bulb holder of lead there. only the lead from the harness and ends in a block connector with 3 pins in it.my question is,is the red wire positive ,black neg,what is the red /yellow for? [signal from reverse light switch?]iv got bulb holders luyin round and just wanna wire it up.its not much easer with a hang over.haha.. thanks .
10-10-07, 01:26 AM
#5
What's your point ?
Join Date: Feb 2001
Location: Gainesville, Fla.
Posts: 3,573
Likes: 0
Received 0 Likes
on
0 Posts
Your best bet is to get a meter and use it to make sure which is the power and which is the ground. There just backup lights so it can't be too difficult.
Thread
Thread Starter
Forum
Replies
Last Post