resistor trick for non-sequentialI need
Thread Starter
Junior Member
Joined: Mar 2002
Posts: 22
Likes: 0
From: Birmingham Al
resistor trick for non-sequentialI need
I need help with the resistor set up for a full non-sequential setup. All of the solonoids are gone and all emissions are gone also. I know there is a Radio Shack resistor mod to keep ck engine light off. I just cant seem to find the info. Thanks
Check your service manual for the range for the resistance that each soleniod/etc is suppose to provide.
If you don't have a manual, you can go to www.iluvmyrx7.com and to the appropriate section for your year model service manual in PDF. Hope that helps!
If you don't have a manual, you can go to www.iluvmyrx7.com and to the appropriate section for your year model service manual in PDF. Hope that helps!
Recovering Milkaholic
iTrader: (7)
Joined: Jan 2002
Posts: 8,206
Likes: 0
From: Budds Creek, Maryland
PM Dont be a Rikki. I helped him tape his up earlier today. He should be able to tell you what to get. He said it cleared alot of break up in the high RPM out.
Trending Topics
Passenger
Posts: n/a
Originally posted by rx7speed811
if i am running a power fc and do the full non seq mod, can i just cut off all the solenoids and be good to go? or do i need to trick it with resistors too?
if i am running a power fc and do the full non seq mod, can i just cut off all the solenoids and be good to go? or do i need to trick it with resistors too?
Hey boost I was talking about removing the FP reg solenoid so you were close. My idle is soooo smooth....
-Rikki
1JZ powered
Joined: Jul 2001
Posts: 4,423
Likes: 0
From: Where there's only two seasons, hot and wet! I love Okinawa
Originally posted by rx7speed811
if i am running a power fc and do the full non seq mod, can i just cut off all the solenoids and be good to go? or do i need to trick it with resistors too?
if i am running a power fc and do the full non seq mod, can i just cut off all the solenoids and be good to go? or do i need to trick it with resistors too?
Thread
Thread Starter
Forum
Replies
Last Post