Replacing gaskets
#1
Replacing gaskets
My FD recently developed an exhaust leak, presumably from the block to manifold gasket.
I decided to replace all three gaskets(block to mani, mani to turbo, turbo to dp).
I have ordered the gaskets, but i also want to replace the hardware with high quality studs and nuts/bolts.
What sizes would i need of these, and how many of each, and where?
I am also going to clean out the threads before installing the new fasteners, and am wondering, what size tap/die i would need?
This is a bit new to me as far as replacing fasteners and cleaning threads out. Any tips to go along with this?
I decided to replace all three gaskets(block to mani, mani to turbo, turbo to dp).
I have ordered the gaskets, but i also want to replace the hardware with high quality studs and nuts/bolts.
What sizes would i need of these, and how many of each, and where?
I am also going to clean out the threads before installing the new fasteners, and am wondering, what size tap/die i would need?
This is a bit new to me as far as replacing fasteners and cleaning threads out. Any tips to go along with this?
#2
Recovering Miataholic
I would direct these questions to Ray Crowe at Malloy Mazda. He probably knows all the hardware part numbers and could also help you with tap sizes.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
t-von
3rd Generation Specific (1993-2002)
9
09-10-15 01:56 PM