3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

replacing fuel door cable

Old Sep 3, 2007 | 04:56 PM
  #1  
Jimbo Sage's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Sep 2006
Posts: 59
Likes: 0
From: Carlisle, PA
replacing fuel door cable

Has anyone replaced a fuel door cable? I made an attempt to locate it after removing a lot of the interior at the rear in the luggage compartment, and I stopped as it looked like it was going to require tearing a lot more out. My latch is broken off and I assume that the cable is connected to it. Has anyone redesigned the system in this area to avoid the replacement of cable?
Thanks
Reply
Old Sep 3, 2007 | 09:04 PM
  #2  
Maximum's Avatar
Rotary Enthusiast
Tenured Member 20 Years
iTrader: (5)
 
Joined: Mar 2005
Posts: 791
Likes: 0
From: Boxford, MA
I replaced my fuel door cable a couple of weeks ago. It's not terribly difficult and the manual describes what you need to remove very clearly. Basically any of the interior plastics from the center of the trunk up to the lever need to be removed. Good luck, just be careful not to snap anything.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Th0m4s
Build Threads
25
Feb 26, 2019 02:04 AM
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM
82streetracer
1st Generation Specific (1979-1985)
7
Aug 23, 2015 09:28 AM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 04:29 AM.