replacing fuel door cable
#1
Full Member
Thread Starter
Join Date: Sep 2006
Location: Carlisle, PA
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
replacing fuel door cable
Has anyone replaced a fuel door cable? I made an attempt to locate it after removing a lot of the interior at the rear in the luggage compartment, and I stopped as it looked like it was going to require tearing a lot more out. My latch is broken off and I assume that the cable is connected to it. Has anyone redesigned the system in this area to avoid the replacement of cable?
Thanks
Thanks
#2
Rotary Enthusiast
iTrader: (5)
Join Date: Mar 2005
Location: Boxford, MA
Posts: 791
Likes: 0
Received 0 Likes
on
0 Posts
I replaced my fuel door cable a couple of weeks ago. It's not terribly difficult and the manual describes what you need to remove very clearly. Basically any of the interior plastics from the center of the trunk up to the lever need to be removed. Good luck, just be careful not to snap anything.
Thread
Thread Starter
Forum
Replies
Last Post
82streetracer
1st Generation Specific (1979-1985)
7
08-23-15 09:28 AM