Replace Stock gauges with Aftermarket
#1
Full Member
Thread Starter
Join Date: Feb 2006
Location: Richmond, Virginia
Posts: 138
Likes: 0
Received 0 Likes
on
0 Posts
Replace Stock gauges with Aftermarket
I want to replace the stock oil pressure and water temp gauges with aftermarket gauges. I have not seen the clusters or even know if it is possible. I know I can buy gauge pods, etc. but there is no point in me having a 2 of the same gauges. Has anyone tried it? Give me any insight? Is this plain stupid? Let me know. Thanks guys.
#3
Rotary Freak
Join Date: Dec 2001
Location: Macungie, Pennsylvania
Posts: 1,802
Likes: 0
Received 0 Likes
on
0 Posts
I think you better stick with what you have. If you put let's say, autometer gauges there, I think it would look stupid. Check this out. Besides changing the faces, leave the stock cluster alone!
Last edited by chinaman; 04-21-06 at 06:14 PM.
#5
~17 MPG
iTrader: (2)
The person who did the first install, with SPA gauges, goes by maxcooper on these forums. Here's his site:
http://www.maxcooper.com/rx7/
There's another guy , maxpesce , who installed Autometer gauges using this same technique:
https://www.rx7club.com/showthread.p...9&page=2&pp=15
-s-
http://www.maxcooper.com/rx7/
There's another guy , maxpesce , who installed Autometer gauges using this same technique:
https://www.rx7club.com/showthread.p...9&page=2&pp=15
-s-
#6
Will u do me a kindness?
iTrader: (2)
Originally Posted by nashman69g
there is someone on here that replaced all his gauges w/Autometer guages...
I plan on doing the same with all Autometer Nexus gauges if they ever release a proper tach and speedo. If not, my hope is Defi will release the Supersports Cluster over here in Imperial units.
#7
Senior Member
That sure is some trick set of gauges there.
And I thought installing a 99-model boost gauge into a 92-model oil pressure gauge position was being trendy.....
Keep up the good work...
And I thought installing a 99-model boost gauge into a 92-model oil pressure gauge position was being trendy.....
Keep up the good work...
Thread
Thread Starter
Forum
Replies
Last Post