3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

quick temp question.

Thread Tools
 
Search this Thread
 
Old Aug 22, 2007 | 11:19 PM
  #1  
turboIIrotary's Avatar
Thread Starter
Rotary Freak
Tenured Member: 15 Years
iTrader: (9)
 
Joined: Feb 2007
Posts: 2,618
Likes: 3
From: dayton,ohio
quick temp question.

how far up the stock gauge does your temp go to?
Reply
Old Aug 22, 2007 | 11:28 PM
  #2  
YOUWSH's Avatar
Senior Member
Tenured Member 05 Years
 
Joined: Apr 2004
Posts: 558
Likes: 0
From: Sydney Australia
At normal operating temperature mine sits slightly lower than the middle.

Not sure if its meant to be sitting dead set in the middle or maybe its the angle I have my drivers seat which makes it look like that.

I've only seen it climb above the middle once and the buzzer went off straight away and I just shut off the car.
Reply
Old Aug 22, 2007 | 11:31 PM
  #3  
turboIIrotary's Avatar
Thread Starter
Rotary Freak
Tenured Member: 15 Years
iTrader: (9)
 
Joined: Feb 2007
Posts: 2,618
Likes: 3
From: dayton,ohio
ok thanks thats where mine is i was just making sure thats where it is suppose to be
Reply
Old Aug 23, 2007 | 02:12 AM
  #4  
rexhvn's Avatar
Rotary for life!
Tenured Member 15 Years
 
Joined: Oct 2005
Posts: 1,155
Likes: 1
From: Somewhere...
The stock gauges are not accurate... they give you a range. Lower than middle is normal but not neccessarily warm. I have an aftermarket temp gauges (recommended to purchase), when my stock guage hits the middle ish after just starting it, or driving it, my aftermarket gauge still says 40 degrees meaning its still very cold, so their not accurate.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
Oct 7, 2015 04:04 PM
island fd
3rd Generation Specific (1993-2002)
6
Sep 18, 2015 07:59 PM




All times are GMT -5. The time now is 04:54 AM.