Quick clutch question....help!! Hah....
#1
Junior Member
Thread Starter
iTrader: (4)
Join Date: Jul 2010
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Quick clutch question....help!! Hah....
Hi guys my freking clutch went out and I have a track day this weekend and I need a clutch hah...... I think I have a factory flywheel, so would a excedy stage one clutch kit fit on the factory flywheel, I will get it resurfaced.
Thanks in advance
Yash
Thanks in advance
Yash
Last edited by streedyash; 03-26-12 at 09:41 PM.
#2
RX-7 Bad Ass
iTrader: (55)
Yep, bolts right up. That's a very nice clutch kit too, I've installed a few.
I wouldn't sweat getting the flywheel resurfaced. Go over it with some sandpaper to knock the glaze off, clean it well with brake clean, you're good to go. Even if it looks bad, as long as it's flat, not gouged, etc. you're fine.
Dale
I wouldn't sweat getting the flywheel resurfaced. Go over it with some sandpaper to knock the glaze off, clean it well with brake clean, you're good to go. Even if it looks bad, as long as it's flat, not gouged, etc. you're fine.
Dale
#3
Junior Member
Thread Starter
iTrader: (4)
Join Date: Jul 2010
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Thank you Dale.
Yep, bolts right up. That's a very nice clutch kit too, I've installed a few.
I wouldn't sweat getting the flywheel resurfaced. Go over it with some sandpaper to knock the glaze off, clean it well with brake clean, you're good to go. Even if it looks bad, as long as it's flat, not gouged, etc. you're fine.
Dale
I wouldn't sweat getting the flywheel resurfaced. Go over it with some sandpaper to knock the glaze off, clean it well with brake clean, you're good to go. Even if it looks bad, as long as it's flat, not gouged, etc. you're fine.
Dale
Thread
Thread Starter
Forum
Replies
Last Post