I just bought two bosch 1600cc injectors, walbro 255lph fuel pump, and a fuel rail to accept the injectors. I am running a PFC. Do I need to use a resistor with these injectors? Also, do I need to remove the accelerated warm up stuff to install the fuel rail? I tried searching, but didn't come up with anything. Sorry for the questions, I just don't want to screw anything up by installing it wrong. Thanks for your help!

-Jesse Parker

 

you need to remove the ACV to install most of the aftermarket fuel rails and yes you will need the resistors for the 1600s with the PFC.

~Luke

 

Do I need a block off plate to remove it? What size resistor will I need and what wire do I connect it to? Thanks again!

 

yes you will need a block of plate, i suggest getting them all from RX7Store.net or k2rd.com. search for resistor size its something like 10w/10ohm but search about that one.

~Luke

 

Thanks a lot Luke! Haha, and I thought I had everything to put this in... doh!

 

i can do the same for $285 shipped. so

 

Thanks guys, but I already had everything except the block off plates (well, and resistors). I ordered them from rx7sotre.net a couple nights ago.