ok, i f take the pill out for the wastegate i get a perfect 7 psi, if i put the stock pill in i get 10 psi, when i put my boost controller (dawes) on, i get 10psi and cannot change that, wether i tighten or loosen it, i also hear a leak after 4300 RPM, and am getting 7 psi on my secondary, it is not the CRV becuase i have capped it and have gotten the same exact boost pattern, and still hear the noise.

 

With your DAWES controller, it should be connected between the #1 turbo outlet and the WG actuator. There should not be any bleed off pills/devices in that circuit.

The outlet hose from the WG actuator should not connect to the piping that goes up to WG solenoid unless you want to try a combination controller. Instead, on this outlet nipple; you should
install a small bleeder pill.

I have a similar device that was made for 4 bangers. The pill sizes it came with were way too large. Install the stock WG pill there.
Or even a smaller pill.

 

so i disconnect the hose that comes out of the side of the waste gate actuator?

 

You only want the DAWES controlling the WG actuator, that is why the hose going from it to the WG solenoid is removed and the pill moved there.