i am wondering if anyone would know if the 3rd gen and a 2nd gen middle plate is the same. i no the port is smaller on the 2nd gen but can it be ported out to work for the third gen thanks alot

 

Are you talking about a rotor housing?

 

not the housing the middle iron

 

The FC center iron is where the motor mount attaches, not the end iron like the FD. There's 3 large holes on the passenger side where the motor mount sandwiches on top of the oil pan. Trying to get an oil pan to properly seal up there would be a royal chore.

I wouldn't bother trying to use an FC iron. FD irons shouldn't be too pricey for a good used one.

Dale

 

thanks very much i appriate it

 

thanks for the help guys i guess i will get a fd iron