Pwr Radiator=quality Product
#1
Senior Member
Thread Starter
Join Date: Aug 2001
Location: SC
Posts: 261
Likes: 0
Received 0 Likes
on
0 Posts
Pwr Radiator=quality Product
Grettings gang!
Installed my PWR radiator yesterday, and I want to praise a quality product. Fit and finish was excellent, and it hauls the temps right back down after some hard running. I installed it after seeing some scary temps on my new temp gauge (why do they even install that factory junk?) and it works! I'll pass final judgement on it when I hit a track day next month. I guess it's pretty with the polished tanks and all, but who can see their radiator anyway? I hauled the old one out the top in about 2.5 hours, including notching the battery tray to get the hardware off of my M2 medium IC.
That's my story,
Steve Bertok
www.panicmotorsports.com
Installed my PWR radiator yesterday, and I want to praise a quality product. Fit and finish was excellent, and it hauls the temps right back down after some hard running. I installed it after seeing some scary temps on my new temp gauge (why do they even install that factory junk?) and it works! I'll pass final judgement on it when I hit a track day next month. I guess it's pretty with the polished tanks and all, but who can see their radiator anyway? I hauled the old one out the top in about 2.5 hours, including notching the battery tray to get the hardware off of my M2 medium IC.
That's my story,
Steve Bertok
www.panicmotorsports.com
#3
Senior Member
Thread Starter
Join Date: Aug 2001
Location: SC
Posts: 261
Likes: 0
Received 0 Likes
on
0 Posts
The lower tab on the drivers side touches the big nut of my oil cooler line, but I wiggled things in that area and don't see it as a problem. Worst case would be a few miuntes from underneath with a dremel for some extra clearance. It would probably make disconnecting the oil coler line a bigger pain then it already is, but other than that, I'm not sweating it.
#6
Rebreaking things
Join Date: Jun 2001
Location: 1 foot in Boston 1 in NJ
Posts: 2,586
Likes: 0
Received 0 Likes
on
0 Posts
I've been running mine for a couple months now with a Greddy FMIC and am very happy with it. It does rub the bottom of IC intake pipe ever so slightly, but I think this could be fixed by sliding over the rad mount adaptors that come with the greddy IC.
Thread
Thread Starter
Forum
Replies
Last Post
[For Sale] Scratch & Dent, Used, and Open-Box Sale!
SakeBomb Garage
Vendor Classifieds
5
08-09-18 05:54 PM
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
10-09-15 10:05 PM