PVC Loose piping
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Nov 2005
Location: Malta (Europe)
Posts: 426
Likes: 0
Received 0 Likes
on
0 Posts
PVC Loose piping
I have a problem with boost. Whenever the second turbo kicks in, the boost falls down to 0.5 bar and stays constant at 0.5. Yesterday i noticed that the pvc piping conacted to the bov (the one at the back) was really loose. Could this be the reason? I'm sorry, but i'm a bit new with fds so any help would be really appreciated. Thanks! (P.s my fd is stock)
#2
That was once rubber. They harden over time because of the heat. Time for a new hose. It might be your boost problem. You know it needs to be fixed. Fix it and see what happens.
-Max
-Max
#4
Mr. Links
iTrader: (1)
ITR, that is a pre-formed hose for the CRV (the BOV looking thing on the rear section of the y-pipe).
If you have a problem with it where you need to replace it; you can usually go to a local auto store and rumage through their pre-formed heater hoses (for other cars) to something with about the right diameter and a 90 degree bend. Then just cut it to size.
If you have a problem with it where you need to replace it; you can usually go to a local auto store and rumage through their pre-formed heater hoses (for other cars) to something with about the right diameter and a 90 degree bend. Then just cut it to size.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM