Profec B
04-11-04, 07:15 AM
#1
Newbie
Thread Starter
Join Date: Apr 2004
Location: Okinawa Japan, El Paso Tx.
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Profec B
I just bought a Greddy profec b and when I installed it, it was not controlling any boost. It would go up to 13 then it would just drop to 0 and I would not get anymore boost. I know it did not install it correctly. Can someone help me out and give me a link to a how to site, some picture of how it is set up or something like that. I have stock twins right no. Thanks
04-11-04, 11:17 AM
#3
Powered by** Rotary
you probably have to set your Balance **** first. Before I set mine, i had lost around 2psi, but never went to 0. You might have installed something incorectly.
Amel
Amel
04-11-04, 11:35 AM
#4
Full Member
Join Date: Apr 2002
Location: Thousand Oaks, CA
Posts: 184
Likes: 0
Received 0 Likes
on
0 Posts
The minimum boost you should see is 7 psi or about that. That is the spring pressure on the waste gate. It can make your boost go higher but I don't see how it could make your boost 0. All it does is control the amount of pressure going to the waste gate.
Thread
Thread Starter
Forum
Replies
Last Post
24seven_dada
3rd Generation Specific (1993-2002)
20
11-10-18 12:03 PM
RexTech
3rd Generation Specific (1993-2002)
3
10-17-01 10:33 AM