Power Steering Snap Ring
05-06-13, 07:13 AM
#1
Work in Progress
Thread Starter
Power Steering Snap Ring
Ok, i have managed to lose my name snap ring when putting my power steering rack back together.
Any one know the spec so i can order a replacement?
Any one know the spec so i can order a replacement?
05-06-13, 07:57 AM
#2
RX-7 Bad Ass
iTrader: (55)
Yeah, you're in a bad way there. Taking apart the rack is pretty uncommon, so I doubt anyone would have a size or spec for you to buy.
Best bet is to find someone with a junk rack they could pull it off of for you or buy a junk rack for parts.
Dale
Best bet is to find someone with a junk rack they could pull it off of for you or buy a junk rack for parts.
Dale
05-09-13, 03:20 PM
#3
Rotary Freak
If you have the rack off the car and haven't got the equipment to measure the bore and groove, CBC bearings is the agent for circlip australia and carry the DIN standard stuff, I'm sure they could fix you up for loose change...may have to buy a small packet of them.
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM