ok so i bought a automatic whoop dee doi got it for 4,000 running with 70k on it and a clean title lol but i converted it to 5 speed single turbo monster port motor no emisions yada yada so i put in a stock manual engine harness and yes i had to do some repinning to make it plug into the dash harness lol my question is will the power fc work properly even with the automatic dash harness still in the car?

 

If you have the stock ECU working then the Power FC will work

 

i am not going to bother running the stock ecu i want to run power fc and i dont know if it will work?

 

It will work.

 

Step 1 - remove stock ECU, deposit in trash.
Step 2 - Install PFC in car, tune and enjoy.

End of installation





Later

 

see i tore the automatic car down i did the manual swap built the engine for 500hp and went single turbo i put the manual ENGINE harness in and made it mate with the auto in dash harness i am just wonder if there will be any interference?i have not ran with the manual ecu yet i just want to run power fc

 

NO....WELL....what the hell else do you need ?

You have the answer - YES, SI, OK, It will work - IF - you did YOUR homework right and wired the car up properly. You should of ended up with 4 yellow ECU connectors that you plug into the PFC and ignition up. Then Tune, Then enjoy.

If you did NOT do your homework right, and YOU wired the harness connections wrong then disasterous results could be your reward. ALWAYS....ALWAYS, triple check your wiring connections before powering up.


End of story



LAter