Is it possiable to goo too cold
08-10-02, 05:47 PM
#1
Junior Member
Thread Starter
Join Date: Jun 2002
Location: Alburne
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
Is it possiable to goo too cold
I am thinking of placing that new N-ter Cooler (the thing that sparys Nitrous on your IC) on My FD along with WaterInjection. I also have a set up that sparys water on My IC pipes to reduces the tematures even more. As well as on the radiator so I can drive it in trafffic. Im into the water cvan u tell. But anyway back to the question is it possiable to go too limiting out freesing the water injection. Lets say 35-40F will it hurt my motor or is it ok.
08-10-02, 06:06 PM
#3
Um Yes, you can go to cold. What kind of ECU do you run??? A member just blew his motor using the N-ter cooler, and other mods using a PFC. The stock intake temp sensor did not compensate for the extra cold charge (more dense) because it didn't react fast enough to add the extra fuel.
While it is a very good thought in theory, and I too plan on using something like the N-ter Cooler, it is very risky to try and do something like this without proper testing and tune time.
Good Luck.
While it is a very good thought in theory, and I too plan on using something like the N-ter Cooler, it is very risky to try and do something like this without proper testing and tune time.
Good Luck.
Thread
Thread Starter
Forum
Replies
Last Post
frosty1993
General Rotary Tech Support
3
09-30-15 01:27 PM