Poor mans non-sequential
#1
Junior Member
Thread Starter
Join Date: Aug 2007
Location: Finland
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
Poor mans non-sequential
Hey guys, id like to test non-seq setup with poor mans mod.. I have tried to find instructions from this site but all the links doesnt exist anymore. Is there instructions to it somewhere, ive understand that i should take off almost all vacuum hoses from rats nest but dunno what and where.. and what else i need to do there ?
#4
Junior Member
Thread Starter
Join Date: Aug 2007
Location: Finland
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
i want to change it to simplyfy troubleshooting and actually i have little problems with it.. after i acclererate so that both turbos are working and if i lift my foot off the gas pedal for example changing gears i got about 0.1 bar boost, and when i lift my foot up again and wait for a while and accelerate the boost is back.. I havent found solution to this problem yet..
I will soon have all boltons, pfc and straight pipe so i think there wount be considerable lag with non sequential setup.
Could you paste link to the site plz
I will soon have all boltons, pfc and straight pipe so i think there wount be considerable lag with non sequential setup.
Could you paste link to the site plz
#5
Top's always down
iTrader: (5)
you'll have crappy lag no matter how many supporting mods you have with "poor mans" non-sequential. it's just a crappy, half assed way to do it.
http://www.nopistons.com/forums/inde...non-sequential
http://www.nopistons.com/forums/inde...non-sequential
Thread
Thread Starter
Forum
Replies
Last Post
Snook
3rd Generation Specific (1993-2002)
17
02-27-21 02:54 PM
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM