Quick question for the powers that be,
I just replaced my turbo's on the car and while putting the car back together I figured that I would replace some of the vaccum lines down around the actuators. Well I replaced the bottom actuators vaccum line that had the pill in it.
1.) I think I put it in the right way (keep my fingers crossed)

2.) I used 5/16 vaccum hose which the inside diameter might be a smiggen larger than stock. I still had to push and work the pill into the vaccum line, but i was wondering do you think I should worry about the turbo pushing the pill though the vaccum line into the actuator or being sucked into the turbo (I doubt the last one).


Anyway just looking for some 0.02 cents from some people.


TIA
Matt

 

I just did the same also and was wondering if the pill orientation mattered? Which end should be pointing towards the actuators?

 

i think that the pill orientation does matter...
I hope I put the pill in correctly. Luckily i only replaced that one line so if something doesn't act correct than I know what line to turn around!
Matt