Pigtail for the O/2 sensor
#1
Rotary Freak
Thread Starter
Join Date: Jan 2002
Location: Overland Park, KS
Posts: 2,360
Likes: 0
Received 0 Likes
on
0 Posts
Pigtail for the O/2 sensor
Has anyone made one of these before? If so how did do you do it? What gaugfe of wires did you use? Any tips? I decided to go this way after seeing how much more i could mess up my car with doing it on the ecu side of the firewall and looking for hours but no discription could help my find that black wire on the 16 conn accross from the white with blue strip. Any help would be great.
Thanks
~Luke
Thanks
~Luke
#2
Senior Member
Join Date: Oct 2001
Location: The 'Nati, Ohio
Posts: 291
Likes: 0
Received 0 Likes
on
0 Posts
I am guessing that you are trying to tap into the O2 sensor wire for a a/f gauge?
If you want to tap into the wire in the engine bay, I recommend doing the tap on the side of the connector toward the down pipe. This is what I did. I just used a splice connector from Radio shack. You just put it over the wire you want to tap into, and slide your wire to run inside the cabin in the other side...and press down. You need to make sure you keep the wire away from anything hot, and maybe even tape up the splice connector to protect it from moisture.
Email me if you need help....
paw@ite.com
Later,
Patrick
If you want to tap into the wire in the engine bay, I recommend doing the tap on the side of the connector toward the down pipe. This is what I did. I just used a splice connector from Radio shack. You just put it over the wire you want to tap into, and slide your wire to run inside the cabin in the other side...and press down. You need to make sure you keep the wire away from anything hot, and maybe even tape up the splice connector to protect it from moisture.
Email me if you need help....
paw@ite.com
Later,
Patrick
Thread
Thread Starter
Forum
Replies
Last Post
killerrx710
2nd Generation Specific (1986-1992)
1
09-24-15 10:57 PM
rotor_veux
2nd Generation Specific (1986-1992)
7
09-19-15 07:13 PM