Scrub, PM'd on FPR placement.

 

Very useful information, makes my build that much easier!

 

feed is the right side stainless line. into the rear side of the stock primaries.

return loops to the FPR and under that is a 90* to the far left stainless hose.



i just didn't want to use any old rubber lines in my setup.

also, dont use the summit 90* fittings... they leak like a siv!

 

I did something similar to Crispy for my fuel feed/return on the firewall. Haven't had any issues with leaking.


The hard lines sit closer to the firewall usually. I had to pull the lines out a bit when installing the AN adapters.

 

Good day all,

Is anyone able to confirm if these fuel lines are in the spot and which each one is for, I took photos before dismantling but the hard drive they where stored on has died.

There are three pipes coming up the fire wall and three hardlines on the block.

I'm aware that one is feed, another return and one from the charcoal canister but unsure of which is which and what hardline they should go to .

Thanks

 

We can't tell where the rubber hoses go so can't confirm if it's correct or not but they go vent , return , feed in that order

 

Thanks for the response that helps loads and has confirmed that I have them in the right locations🙂